Bosch HCP30E51UC Installation Instruction

13

Using 4 screws (4x8 mm), attach the back-pressure flap 

to the extractor hood.

Note:  If an aluminum pipe is used, smooth the 

connection area beforehand.

Attach exhaust air pipe and seal.

Check whether the back-pressure flap works.

Use 4 screws (4x8 mm) to screw the housing to the 

angle bracket.

Measure the distance (x) between the bottom edge of 

the housing for the recirculation module and the 

bottom edge of the back-pressure flap.

Shorten the exhaust air pipe to the length measured.

Remove the recirculation module.

Push the exhaust air pipe onto the bottom side of the 

recirculation module.

Position the recirculation module with exhaust air pipe 

over the air extraction duct of the extractor hood.

Use 4 screws to fasten the recirculation module to the 

angle bracket.

Secure connections with clamps.

Recirculation module

A

Clamps

B

Flue Duct

C

Exhaust Air Duct

D

Screws

A

Recirculation Module

B

Angle bracket

C