Bosch HMV3022U Installation Instruction

12

Rotate the blower unit counterclockwise 180º.

Gently remove the wires from the grooves. Reroute the 

wires through the grooves on other side of the blower 

unit. Rotate blower unit 90º so that fan blade openings 

are facing out the back of the microwave.

9

Do not pull or stretch the blower unit wiring. Make 

sure the wires are not pinched, and that they are 

properly secured.

Place the blower unit back into the opening.

Replace the blower plate and secure with the screws 

removed in Step 1.

Attach the exhaust adapter to the rear of the oven by 

sliding it into the guides. Push in securely until it is in 

the lower locking tabs. Make sure the damper hinge 

swings freely.

Remove power to outlet.

Remove all contents from upper cabinet.

Tape the TOP CABINET TEMPLATE onto the bottom 

surface. Make sure the template centerline aligns with 

the vertical line on the wall. Rear wall arrows must be 

against rear wall.

Note:  For recessed cabinet bottom, trim the template 

edges so that it fits inside the recessed area. The 

template has trim lines to use as guides.

Drill 3\8" (9,5 mm) holes at "A", "B" and "C".
Note:  Wear safety goggles when drilling holes in the 

cabinet bottom.

Cut out the 2" (50,8 mm) hole at "D". This hole is for 

the power supply cord.

Note:  If the cabinet is metal, use the nylon grommet 

around the opening to protect the cord.

Roof venting installation only: Cut out the shaded 

area "E" on the template, using a saber or keyhole 

saw.

'

(