Bosch HBLP751UC Installation Instruction

English 5

3. Install the decorative trim.

4. Place the microwave oven unit on top of the universal 

connector brackets and fasten in place using three 
screws per side. Tighten the screws securely, but do 
not overtighten.
Note: The existing screws in the microwave base help 
with alignment. When lowering the microwave into 
place on the universal connector bracket, allow these 
screw heads to slide into the slots as shown in the 
illustration below. The screw nearest the front of the 
microwave slides into the base of the slope at the front 
of the bracket.

5. Continue with the unit installation in the following 

sections on electrical connection and installing the 
oven unit into the wall cabinet.

Note: Do not place the oven into the wall cabinet until after 
mounting the steam oven on it using the universal connec-
tor brackets.
1. Remove the six screws holding the combo service slide 

assemblies to the support bracket. Use a magnetic 
screwdriver bit to reach the screws through the large 
holes in the tops of the slides.

Position the decorative trim 
piece so the flanges with 
the holes in them face 
away from the oven door.
Align the outer flanges with 
the outside of the universal 
brackets. Fasten with 1 
screw each into the end 
hole of the universal 
bracket. Tighten screws 
securely, but do not 
overtighten.