Maytag MDG25PRAWW Instruction Manual
3
7. Attach the card reader to the inside of the card reader bezel
per instructions from the card reader manufacturer.
8. Install the assembled card reader-bezel assembly into
the control panel and secure with the 2 screws in literature
package.
9. Plug the wiring harness into the card reader and the card
reader port on the control board at AA3.
10. Reinstall the console panel assembly and outer control
panel by reversing steps 6 and 4, and for washers, 3.
Dryer shown.
11. Reinsert detergent dispenser assembly (washer only).
Complete Installation
Check that all parts are now installed. If there is an extra
1.
part, go back through the steps to see which step was
skipped.
Check that you have all of your tools.
Check that you have all of your tools.
2.
3. Dispose of/recycle all packaging materials.
Washers & Gas Dryer
4.
Plug into a grounded 3 prong outlet.
Electric Dryers
Electric Dryers
5.
In the U.S.A.:
For power supply cord installations, plug into a grounded
For power supply cord installations, plug into a grounded
(earthed) outlet. For direct wire installations, turn on power.
In Canada:
Plug into a grounded 4 prong outlet. Turn on power.
In Canada:
Plug into a grounded 4 prong outlet. Turn on power.
Assistance or Service
If you need assistance:
Contact the distributor where the washer was purchased or visit
Contact the distributor where the washer was purchased or visit
www.whirlpoolcommerciallaundry.com.
When you call, you will need the washer model number and
When you call, you will need the washer model number and
serial number. Both numbers can be found on the serial-rating
plate located on your washer.
A. Card reader bezel and card reader
A