Monogram ZDP486NDPSS Installation Instruction

Save these instructions for

local inspector’s use. 

Observe all governing

codes and ordinances.

Be sure to leave these

instructions with the Consumer.

Keep these instructions 

with your Owner’s Manual for future reference.

• Proper installation is the responsibility of the

installer. Product failure due to improper
installation is not covered under the warranty.
See Owner’s Manual for warranty information.

This appliance must be properly grounded. 
See ”Electric Supply.”

For Monogram local service in your area, 
1.800.444.1845.

For Monogram Service in Canada, call 
1.800.561.3344.

For Monogram Parts and Accessories, call 
1.800.626.2002.

If you received a damaged range, you should
contact your dealer.

In the Commonwealth of Massachusetts:
• This product must be installed by a licensed

plumber or gas fitter.

• When using ball type gas shut off valves, they

shall be T-handle type.

• A flexible gas connector, when used, must not 

exceed 3 feet.

It is recommended that these ranges be installed 
in conjunction with a suitable overhead vent hood.
• Install a hood with at least 1200 CFM above a 48

"

wide range.

• Install a hood with at least 600 CFM above a 30” 

or 36” range.

Due to the high heat capacity of this unit, particular
attention should be paid to the hood and ductwork
installation to assure it meets local building codes.

Clearances to horizontal surfaces above the range, 
measured to the cooking surface:

• Installations without a hood require 48” minimum 

to combustibles.

• A custom hood installation with exposed 

horizontal combustibles surfaces must have 
an Auto-On feature.

• For other installations with a hood, refer to hood 

installation instructions for specific hood 
clearances.

These ranges weigh up to 700 pounds. Some
disassembly will reduce the weight considerably.
Due to the weight and size of the range and to
reduce the risk of personal injury or damage to 
the product:

TWO PEOPLE ARE REQUIRED FOR PROPER
INSTALLATION OF 36" AND 30" RANGES.

THREE PEOPLE ARE REQUIRED FOR PROPER
INSTALLATION OF 48" RANGES.

All ranges can tip. Injury could result. Install the
supplied Anti-Tip Bracket provided. See instructions
in this manual or with the bracket.

Leak testing of the appliance shall be conducted
according to the manufacturer’s instructions.

Installation must conform with local codes. In the
absence of local codes, the range must comply with
the National Fuel Gas Code, ANSIZ223.1/NFPA 54,
latest edition and National Electrical Code
ANSI/NFPA 70 latest addition. In Canada, installation
must conform with the current Natural Gas
Installation Code, CAN/CGA-B149.1 or the current
Propane Installation Code, CAN/CGA-B149.2, and 
with local codes where applicable. This range has
been design-certified by CSA International according
to ANSI Z21.1, latest edition and Canadian Gas
Association according to CAN/CGA-1.1 latest edition.