Frigidaire FGGF3058RW Owner's Manual

23

If the error message “Prob ERR” displays (Fig. 1), check 

to be sure that the probe connector is fully inserted 

into the receptacle. If the probe is fully inserted in the 

receptacle and the error message continues, the probe 

may be defective and need replaced.
When “Prob ERR” displays, the oven control will not 

permit any oven feature to activate until corrected or the 

probe is removed. If the error message continues, remove 

the probe from the receptacle and oven.

Fig. 1

“Probe Too Hot” message:
When the message “Prob” ... “Too”... “Hot” ... flashes in 

the display, the probe sensor temperature has exceeded 

250°F (121°C). If the probe is not removed this message 

may continue until the sensor reaches 300°F (149°C) or 

higher, at which time the oven will automatically turn OFF 

and display “Prob ERR” message.
This message may have been generated if the probe 

sensor is exposed to direct oven heat or the food 

internal temperature is over 250°F (121°C). Be sure the 

probe sensor is fully covered by the food or if the food is 

done, press cancel and remove food and probe from the 

oven.

Probe (cont’d)

• During the cooking process the internal food 

temperature will display by default. To review the 

target temperature press the

keypad once. After 

6 seconds the display will revert back to the internal 

food temperature.

• To assure temperature accuracy, do not remove the 

probe from the food or receptacle until the desired 

internal temperature is met.

• If the probe is active and the probe is removed from 

the receptacle only, the probe feature will cancel but 

the oven will continue to cook. 

• If the probe is active and the probe is removed from 

the food only, the probe feature will remain active, but 

the displayed internal food temperature may no longer 

be reliable. This may eventually generate a “Probe 

Too Hot” message.

• The oven will automatically turn OFF if the probe 

sensor reaches 300°F (149°C) or more.

• The probe feature cannot be set with broil or self-

clean.

• To change the target temperature while cooking, 

press the 

keypad once. Use the numeric 

keypads to change the target temperature. Press the 

start keypad to accept any change.

handle

probe

cable

probe

sensor

Fig. 2

handle