Monogram ZIFS360NXRH Manual

17

Anti-Tip Bracket Installation

The wall toggles and bolts can be ordered 
as Service Kit #WR49X10193. Wall toggles 
are installed in the drywall and metal studs 
for stability. Install the wall toggles as follows:

• Drill 1/2" holes at the wall markings made 

in the holes at the ends of the wall bracket.

• Hold the metal channel flat against the plastic

straps and slide the channel through the hole.

• Gently pull back at the ends of the plastic

straps to make the channel rest flush behind
the wall.

• Hold the ends of the straps in one hand 

and slide the plastic cap along the straps until
the flange of the cap is flush with the wall.

• Place your thumb between the plastic straps

and bend up and down to snap the straps off 
at the wall.

• Have someone hold the wall bracket centered 

in place with each of the holes aligned with 
the correct opening in the bracket and level 
with the horizontal line.

• Insert the lag screws through the bracket 

and into the stud. Tighten with a wrench.

• Insert the bolts into the toggle by hand until

snug. Tighten with a wrench.

Anti-Tip Wall Bracket

Bolt

Wall Toggle

Drywall or
Steel Stud

Plastic Straps

Metal Channel

Cap

Wood Stud

Lag Screw

Anti-Tip Wall Bracket