Monogram ZDT800SIFII Installation Instruction

• Connect drain line to air gap, waste tee or disposer using 

the previously determined method. Secure hose with a 

screw-type clamp.

With this method you will need the drain hose hanger set 

aside in Step 1. 
Fasten drain hose to underside of countertop with the pro-

vided hanger.

  When connecting drain line 

to disposer, check to be sure that drain plug has been 
removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT 
IN PLACE.

Make sure excess drain hose has been pulled through 

the cabinet opening. This will prevent excess hose in the 

dishwasher cavity from becoming kinked or crushed by the 

dishwasher.

STEP 19   CONNECT POWER SUPPLY

In this step you will need the junction box cover and the #10 
Hex head screw from the screws set aside in Step 1.

•

 Secure house wiring to the back of the junction box with a 

strain relief.

• Locate the 3 dishwasher wires, (white, black and green) 

with the stripped ends coming out of the AC jumper. Use 

UL listed wire nuts of appropriate size to connect incoming 

ground to green, white to white and black to black.

• Install the junction box cover using #10 hex head screw. 

Check to be sure that wires are not pinched under the 

cover.

• Make sure that the junction box cover is resting on the 

mounting bracket.

• If using a Power Cord Kit, please refer to the included 

instructions.

Waste Tee Installation

Disposer Installation

Waste Tee Installation

Disposer Installation

18"

Min.

32"

Min.

32"

Min.

18"

Min.

Drain Hose Hanger

Remove

Drain

Plug

If house wiring is not 2-wire with ground, a ground 

must be provided by the installer. When house wiring 

is aluminum, be sure to use UL-Listed anti-oxidant 

compound and aluminum-to-copper connectors.

Ground 

(Green)

NOTE: Do not remove the 

Junction Box Bracket.

AC 

Jumper

Junction Box 

Bracket

Black

White

Ground Screws