Monogram ZDT800S Installation Instruction

supplied with the dishwasher. 
• Locate the sound insulation package and pre-toekick 

packages inside the dishwasher.

• Stand the parts upright as shown.

•  Locate the control box.

•

  Push insulation block portion under the dishwasher until it 

is beneath the control box.

•  Push the panel portion up to the front of the block.

•  Tuck the sides of the front panel behind the toekick 

attachment screw holes.

•  Open door all the way, if the door doesn’t stay fully open, 

adjust the insulation panel.

•  On models so equipped, position pre-toekick over the 

insulation. Align the screw holes with the screw holes on 

the legs of the dishwasher.

•  On models so equipped, remove the masking tape from the 

sound barrier and door front. Position the sound barrier 

over the insulation.

 

Toekick

Panel

Insulation 

Block

Dishwasher 

Door

Pre- 

Toekick 

Sound barrier 

(On some 

models. Part is 

already attached 

to door.)

Control Box

STEP 25   LITERATURE

• Be sure to leave complete literature package, these Installation    

   Instructions and product samples and/or coupons with the     

   consumer.

STEP 24   REPLACE TOEKICK

•  Place toekick against the pre-toekick and legs of the 

dishwasher.

•  Align the toekick with the bottom edge and make sure it is 

against the floor.

•  Insert and tighten the 2 toekick attachment screws. The 

toekick should stay in contact with the floor.

•  When reinstalling the toe kick on models with a sound 

barrier, ensure that the bottom edge of the rubberized flap 
is flush with the floor. Any excess material should be tucked 
up behind the outer door. Do not allow excess rubberized 
flap to lay on the floor. If any excess is not tucked completely 
behind the outer door, it will bunch up between the door and 
toe kick and impede proper opening and closing of the door. 
This will be noticeable because the door will not stay fully 
open and will spring up.

Attachment 

Screws 

Toekick