Hotpoint HPS18BTHBB Installation Instruction

Page of 56
About storage drawer and cover removal. 
GEAppliances.com
Not all features are on all models.
Cover Removal
To remove:
 Remove the drawers.
 Reach in, push the back of glass cover up, 
and at the same time, pull it backward as 
far as it will come.
Tilt it and take it out. Avoid cleaning the cold 
glass cover with hot water because the extreme 
WHPSHUDWXUHGLȺHUHQFHPD\FDXVHLWWREUHDN
 Remove the drawer frame. (Always remove 
the glass cover before you take out the 
drawer frame.)
/LIWWKHIUDPHRȺWKHVXSSRUWVDWHDFKVLGHDQG
back, pull it forward, tilt it and take it out.
To replace:
 Lower the frame until it rests on the 
supports at each side and back.
 Replace the glass cover, pushing its front 
HGJH¿UPO\LQWRWKHIURQWIUDPHFKDQQHO
and gently lowering the back into place.
 Replace the drawers.
Drawer Removal
Drawers can be removed easily by grasping 
the sides and lifting up slightly while pulling 
drawers past the stop location.
Humidity Controlled Drawer 
(on some models)
Slide the control all the way to the 
HIGH setting to provide high humidity 
recommended for most vegetables.
Slide the control all the way to the LOW 
setting to provide lower humidity levels 
recommended for most fruits.
CAUTION
 
Avoid contact with the 
moving parts of the ejector mechanism, or 
with the heating element (located on the 
bottom of the ice maker) that releases the 
FXEHV'RQRWSODFH¿QJHUVRUKDQGVRQWKH
automatic ice making mechanism while the 
refrigerator is plugged in.
Automatic Ice maker  (on some models).
The ice maker will produce approximately 
70-100 cubes in a 24-hour period, depending 
on the freezer compartment temperature, room 
temperature, number of door openings and other 
use conditions.
If the refrigerator is operated before the water 
connection is made to the ice maker, set the 
switch OFF.
When the refrigerator has been connected to the 
water supply, set the switch ON position.
7KHLFHPDNHUZLOO¿OOZLWKZDWHUZKHQLWFRROVWR
15°F. A newly-installed refrigerator may take 12 to 
24 hours to begin making ice cubes.
Once the ice maker starts to make ice, it may take 
XSWRKRXUVWR¿OOWKHELQGHSHQGLQJRQWKH
temperature settings and number of door openings.
You will hear a buzzing sound each time the ice 
PDNHU¿OOVZLWKZDWHU
NOTICE: 7KURZDZD\WKH¿UVWIHZEDWFKHVRILFH
to allow the water line to clear.
Be sure nothing interferes with the sweep of the 
feeler arm.
:KHQWKHELQ¿OOVWRWKHOHYHORIWKHIHHOHUDUPWKH
ice maker will stop producing ice.
It is normal for several cubes to be joined 
together.
If ice is not used frequently, old ice cubes will 
become cloudy, taste stale, shrink or fuse together.
Ice maker accessory kit:
If your refrigerator did not already come equipped 
with an automatic ice maker, an ice maker 
accessory kit is available at extra cost.
&KHFNWKHEDFNRIWKHUHIULJHUDWRUIRUWKHVSHFL¿F
ice maker kit needed for your model.
About the automatic ice maker 
 
 
A newly-installed refrigerator may take 12–24 hours to begin making ice.
ON OFF
Ice maker
Feeler Arm
Power Switch
5