Hotpoint HPS18BTHBB Installation Instruction

Page of 56
Installation Instructions 
Models 15, 16, 18
7
BEFORE YOU BEGIN
Read these instructions completely and carefully.
 
IMPORTANT –
 
Save these instructions for 
local inspector’s use.
 
IMPORTANT –
 
Observe all governing 
codes and ordinances.
• 
Note to Installer –
 Be sure to leave these 
instructions with the Consumer.
• 
Note to Consumer –
 Keep these instructions 
for future reference.
• Skill level – Installation of this appliance requires 
basic mechanical skills.
• Completion time – Refrigerator Installation 
 15 
minutes
    
Reversing the Door Swing 
 15 
minutes
  Proper installation is the responsibility of the installer. 
  Product failure due to improper installation is not 
covered under the Warranty.
•  Do not install the refrigerator where the temperature 
will go below 55°F (12.7°C) because it will not run often 
enough to maintain proper temperatures.
‡,QVWDOOLWRQDÀRRUVWURQJHQRXJKWRVXSSRUWLWIXOO\
loaded.
REFRIGERATOR LOCATION
Allow the following clearances for ease of installation, 
proper air circulation and plumbing and electrical 
connections.
•  Sides 3/4”
 (19 mm)
•  Top 1”
 (25 mm)
•  Back 2”
 (50 mm)
CLEARANCES
Leveling legs near each front corner of the refrigerator 
DUHDGMXVWDEOH7KH\¿UPO\SRVLWLRQWKHUHIULJHUDWRUDQG
prevent it from moving when the doors are opened. 
Leveling legs should be set so the front of the refrigerator 
is raised just enough that the doors close easily when 
opened about halfway.
Turn the leveling legs clockwise to raise the refrigerator, 
counterclockwise to lower it.
Rollers next to the leveling legs allow you to move the 
refrigerator away from the wall for cleaning.
Turn the legs counterclockwise until the weight of the 
refrigerator is transferred from them to the rollers. After 
rolling the refrigerator back into place, turn the legs 
clockwise until the legs again bear the weight of the 
refrigerator.
ROLLERS AND LEVELING LEGS
If the refrigerator has an ice maker, it will have to be 
connected to a cold water line. A water supply kit 
FRQWDLQLQJFRSSHUWXELQJVKXWRȺYDOYH¿WWLQJVDQG
instructions) is available at extra cost from your dealer, 
by visiting our Website at GEAppliances.com (in Canada 
at www.geappliances.ca) or from Parts and Accessories, 
1.877.959.8688.
WATER SUPPLY TO THE ICE MAKER 
(on 
some models
)
If you have questions, call 1.800.GE.CARES 
or 
visit our Website at: 
GEAppliances.com
 
In Canada, call 1.800.561.3344 
or 
Visit our Website at: 
www.geappliances.ca