Fire Magic 32791X Installation Instruction
4
L-C2-18909
REV 6 - 0906231541
PLANNING FOR INSTALLATION OF YOUR SINGLE SIDE BURNER
Do not install this unit under unprotected
fl ammable surfaces. Do not install or use this
appliance inside a building, garage, or any
other covered area. It must not be used in or
on recreational vehicles or boats.
fl ammable surfaces. Do not install or use this
appliance inside a building, garage, or any
other covered area. It must not be used in or
on recreational vehicles or boats.
This is a built-in type unit designed to fi t into
open-front enclosures. The control panel of the
unit is removable for gas hookup, servicing, and
burner adjustment. The control panel must be
removable after you install the unit.
open-front enclosures. The control panel of the
unit is removable for gas hookup, servicing, and
burner adjustment. The control panel must be
removable after you install the unit.
Important:
This unit should be installed
so that it can be removed at a
later date if factory service is
required. Any protrusion into
the single sideburner enclosure
may prevent the unit from sliding
into place (see GAS SUPPLY
PLUMBING REQUIREMENTS,
on page 4).
later date if factory service is
required. Any protrusion into
the single sideburner enclosure
may prevent the unit from sliding
into place (see GAS SUPPLY
PLUMBING REQUIREMENTS,
on page 4).
ENSURING PROPER COMBUSTION AIR AND
COOLING AIR FLOW
COOLING AIR FLOW
You must maintain proper air fl ow for your Fire Magic
single sideburner to perform as it was designed
(Fig. 4-1). If airfl ow is blocked, overheating and
poor combustion will result. Make sure not to block
the 1" front air inlet along the bottom of the control
panel or more than 75% of the support grid surface
with pans or griddles.
single sideburner to perform as it was designed
(Fig. 4-1). If airfl ow is blocked, overheating and
poor combustion will result. Make sure not to block
the 1" front air inlet along the bottom of the control
panel or more than 75% of the support grid surface
with pans or griddles.
Installer and User Note:
Keep electrical supply cords away from all heated
surfaces.
surfaces.
Fig. 4-1
Ventilation diagram
WHERE TO INSTALL YOUR
SINGLE SIDEBURNER
FOR OUTDOOR USE ONLY.
ELECTRICAL OUTLETS
Electrical outlets in the vicinity of this appliance
must be properly grounded and GFI equipped.
Important:
This unit may be installed into
combustible framing (wood,
for instance) provided there is
a minimum of a
combustible framing (wood,
for instance) provided there is
a minimum of a
1
/
2
" airspace
between the sides of the unit
and any combustible material.
This hanger requires 1
and any combustible material.
This hanger requires 1
1
/
2
" of
countertop on each side and
back to support the unit.
back to support the unit.
Sideburner
Sideburner
Countertop
Counter
Counter
Maintain air gap all the
way down (back and
side) under countertop
Edge of
counter
cut-out
2
1
/
4
"
Hanger
2
1
/
4
"
Min. 1/2"
Max. 3/4"
air gap to all
combustible
material
Fig. 4-1 Top View
Fig. 4-2 Front View
Stainless
steel
hanger
Hanger