Thermador PRG366JG Owner's Manual
English 37
Do-It-Yourself Maintenance
Oven Light Bulb Replacement
Replace only with a recommended light bulb designed for
appliance oven use. DO NOT USE a standard household
light bulb in any oven. Call THERMADOR
appliance oven use. DO NOT USE a standard household
light bulb in any oven. Call THERMADOR
®
Customer Care
Center at 1-800-735-4328 or your nearest THERMADOR
dealer to determine the proper replacement bulb for your
range. You will need to know your range’s model number
and serial number.
dealer to determine the proper replacement bulb for your
range. You will need to know your range’s model number
and serial number.
To Replace the Light Bulb:
Use only 10 Watt, 12 Volt bi-pin halogen light bulbs. Use a
clean, dry cloth to handle halogen light bulbs. This will
increase the life of the bulb.
Use only 10 Watt, 12 Volt bi-pin halogen light bulbs. Use a
clean, dry cloth to handle halogen light bulbs. This will
increase the life of the bulb.
1.
Turn off circuit breaker.
2.
Remove oven racks.
3.
Slide the tip of a flat blade screw driver between the
fixing clip and the lamp housing (Figure 34, A).
fixing clip and the lamp housing (Figure 34, A).
4.
Support the glass lens cover with two fingers along the
bottom edge to prevent the cover from falling to the
bottom of the oven. Gently twist the flat blade screw
driver to loosen the glass lens cover.
bottom edge to prevent the cover from falling to the
bottom of the oven. Gently twist the flat blade screw
driver to loosen the glass lens cover.
5.
Remove the glass lens cover and fixing clip.
6.
Remove the bulb by grasping and sliding the bulb
straight back until the two prongs have cleared the
ceramic holder (Figure 34, B).
straight back until the two prongs have cleared the
ceramic holder (Figure 34, B).
7.
Do not touch the glass of the new replacement bulb
with your fingers. It may cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean dry
cloth. Locate the two prongs in the ceramic holder,
gently poking until the two prongs locate in the ceramic
socket.
with your fingers. It may cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean dry
cloth. Locate the two prongs in the ceramic holder,
gently poking until the two prongs locate in the ceramic
socket.
8.
Press down to seat the bulb (Figure 34, C).
9.
Slide the protective lens into the holder clip and push
the other end until the fixing clip snaps back into the
housing (Figure 34, D).
the other end until the fixing clip snaps back into the
housing (Figure 34, D).
10. Turn on circuit breaker.
CAUTION:
•
Make sure the appliance and lights are cool and
power to the appliance has been turned off before
replacing the light bulb(s). Failure to do so could
result in electrical shock or burns.
power to the appliance has been turned off before
replacing the light bulb(s). Failure to do so could
result in electrical shock or burns.
•
The covers must be in place when using the
appliance.
appliance.
•
The covers serve to protect the light bulb from
breaking.
breaking.
•
The covers are made of glass. Handle carefully to
avoid breaking. Broken glass could cause an injury.
avoid breaking. Broken glass could cause an injury.
•
The light socket is live when the door is open.
Figure 33: Oven Lamp Assembly
Lens
10W
Halogen
Lamp
Halogen
Lamp
Fixing
Clip
Clip
Housing
Ceramic
Holder
Holder
Holder
Clip
Clip
Figure 34: Bulb Replacement
B.
C.
D.
A.