Thermador PRG366JG Owner's Manual
English 38
Power Failure
In the event of a power failure, only the standard burners
can be lit manually. It is necessary to light each standard
burner individually.
can be lit manually. It is necessary to light each standard
burner individually.
All oven knobs and selectors must be set to OFF before
powering up the range. To prevent unintended operation at
power up, please set all oven knobs to OFF. To ensure
customer safety in the event of power failure, the unit will
display an error message upon reinstatement of power
unless all oven knobs are set to OFF. Set all oven knobs to
OFF and reset the breaker to clear the message.
powering up the range. To prevent unintended operation at
power up, please set all oven knobs to OFF. To ensure
customer safety in the event of power failure, the unit will
display an error message upon reinstatement of power
unless all oven knobs are set to OFF. Set all oven knobs to
OFF and reset the breaker to clear the message.
If the range's cooktop is being used when the power failure
occurs, turn all of the burner control knobs to the OFF
position. The standard burners can be lit by holding a
match at the ports and turning the control knob to the HI
position. Wait until the flame is burning all the way around
the burner cap before adjusting the flame to the desired
height.
occurs, turn all of the burner control knobs to the OFF
position. The standard burners can be lit by holding a
match at the ports and turning the control knob to the HI
position. Wait until the flame is burning all the way around
the burner cap before adjusting the flame to the desired
height.
The four ExtraLow
®
burners on the outer sides cannot be
used during a power failure. Be sure to turn them OFF if a
power failure occurs because they will not turn back on
until the control knobs are turned OFF and then turned
back on again. See “WHAT TO DO IF YOU SMELL GAS”
on page 1.
power failure occurs because they will not turn back on
until the control knobs are turned OFF and then turned
back on again. See “WHAT TO DO IF YOU SMELL GAS”
on page 1.
If you have low gas pressure, contact your gas company.
Intermittent or Constant Igniter Sparking
Intermittent or constant sparking of the sealed gas surface burners can result from a number of preventable conditions.
Eliminate these conditions as indicated in the following chart.
Eliminate these conditions as indicated in the following chart.
SYMPTOM
CAUSE
REMEDY
Intermittent sparking
•
Ceramic igniter is wet or dirty.
•
STAR
burner ports are clogged.
•
Carefully dry or clean igniter.
•
Clean ports on STAR
burner cap with a
wire, a needle or straightened paper clip.
More than four clicks of
igniter before lighting
igniter before lighting
•
Improper fit of STAR
burner cap onto
STAR
burner base.
•
Align STAR
burner cap properly on STAR
burner base.
Constant Sparking
•
Range is not properly grounded.
•
Refer to the Installation Manual. Have a
qualified electrician ground the range
properly.
qualified electrician ground the range
properly.
•
Electrical power supply is incorrectly
polarized.
polarized.
•
Refer to the Installation Manual.
Have a qualified electrician ground the
range properly.
Have a qualified electrician ground the
range properly.