Pioneer VSX-824-K Owner's Manual

4

61

9

Refer to the following information when you come up with a 

status message while operating the Network functions.

Use this procedure to reset all the receiver’s settings to the 

factory default. Use the front panel controls to do this.

•

For instructions on resetting the network connection 

settings, see 

Factory Reset on page 49

.

STANDBY/ON

 shows in the display.

 appears in the display to indicate that the receiver 

has been reset to the factory default settings.

•

If the Control with HDMI function is set to ON, the HDMI 

function’s Standby Through is set to anything other than 
OFF

, or the Network Standby is set to ON, you may not be 

able to reset the unit. In this case, reset either by turning 
OFF

 the Control with HDMI function, or by putting the unit 

into standby mode by turning off the power of all the 

connected devices, and resetting after the HDMI indicator 

on the front panel turns off.

•

Use a polishing cloth or dry cloth to wipe off dust and dirt.

•

When the surface is dirty, wipe with a soft cloth dipped in 

some neutral cleanser diluted five or six times with water, 

and wrung out well, and then wipe again with a dry cloth. 

Do not use furniture wax or cleansers.

•

Never use thinners, benzine, insecticide sprays or other 

chemicals on or near this unit, since these will corrode the 

surface.

The selected category or Internet radio 

station cannot be accessed.

Cannot be played back for some 

reasons.

The selected song has not been found 

anywhere on the network.

The selected server cannot be accessed.

The server has been disconnected.

There are no files stored in the selected 

folder.

The license for the contents to be played 

back is invalid.

This is displayed when the file you have 

attempted to register in the Favorites 

folder has already been registered.

This is displayed when you have 

attempted to register a file in the 

Favorites folder but the Favorites folder is 

already full.