Yamaha YSP-2500 Owner's Manual

SETTINGS

➤ Advanced setup

En

• Initializing this unit also initializes measurement results for IntelliBeam and settings stored in system memory. Perform “AUTO SETUP” from the “IntelliBeam” menu again.

TURN ON VOLUME

OFF (Not set) (default), 1 to 70

Set the initial volume level when the power of this unit is turned on.
When set to “OFF”, volume level is the same as when this unit is turned off.

MAX VOLUME

1 to 99, MAX (Maximum) (default)

Set the maximum volume level so that this unit will not output sound beyond the 
limited volume level.

INPUT LOCK

ON (INPUT key operation is disabled)
OFF (INPUT key operation is enabled) (default)

Select whether or not to enable the INPUT key on the center unit.

PANEL LOCK

ON (Key operation on the center unit is disabled)
OFF (Key operation on the center unit is enabled) (default)

Select whether or not to enable key operations on the center unit (except the 
advanced setup operations).

IR INPUT POWER

ON (Enables power-on)
OFF (Disables power-on) (default)

Select whether or not to automatically turn on this unit by pressing an input selector 
key on the remote control when the unit is turned off.

AC ON STANDBY

ON (Enters standby mode) (default)
OFF (Restores the state before power was lost)

Set this unit’s power to off when the AC power is recovered after the power to this 
unit was lost temporally (disconnect the AC power plug from the wall outlet, power 
outage, etc.).

MEMORY PROTECT

ON (Protect is performed)
OFF (Protect is not performed) (default)

Protect the settings you have saved in the system memory.

YRB FL

YES (The reflection board is used)
NO (The reflection board is not used) (default)

Use the YRB-100 sound reflection board for the front left channel. Refer to page 73 
for details of YRB-100.

YRB FR

YES (The reflection board is used)
NO (The reflection board is not used) (default)

Use the YRB-100 sound reflection board for the front right channel. Refer to page 73 
for details of YRB-100.

YRB SL

YES (The reflection board is used)
NO (The reflection board is not used) (default)

Use the YRB-100 sound reflection board for the surround left channel. Refer to page 
73 for details of YRB-100.

YRB SR

YES (The reflection board is used)
NO (The reflection board is not used) (default)

Use the YRB-100 sound reflection board for the surround right channel. Refer to 
page 73 for details of YRB-100.

AUTO POWER STANDBY

ON (This unit turns off automatically) (default setting for U.K., Europe and Russia 
models)
OFF (This unit does not turn off automatically) (default setting other than U.K., 
Europe and Russia models)

When set to “ON”, this unit turns off automatically in any of the following situations:
• Audio is coming from the selected input source. However, no operations have 

been performed for 8 hours or more.

• Bluetooth is selected as the playback device. However, no audio has come out 

from the device or no operation has been performed for 20 minutes or more.

• HDMI 1, 2, or 3 is selected as the playback device. However, the playback 

device has been disconnected from the selected HDMI IN jack for 20 minutes or 
more.

FW UPDATE

02.00.04 (The firmware version is displayed)
START OK? (Firmware is updated)

Confirm firmware version/update firmware.

INITIALIZE

OK (All settings are restored to their default values)
CANCEL (Settings are not restored to their default values) (default)

Reset all of the parameters of this unit to the factory presets. When the unit freezed, 
the problem may solve by restoring to their default values.