Samsung RF263BEAESG/AA Owner's Manual
13_
setting up
.
1
INSTALLING THE WATER
DISPENSER LINE
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
features on your new refrigerator. To help promote
better health, the water filter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20~125psi (138~862 kPa) is required.
For the ice maker to operate properly, water
pressure of 20~125psi (138~862 kPa) is required.
If the refrigerator is installed in an area with low
water pressure (below 20psi), you can install
a booster pump to compensate for the low
pressure.
water pressure (below 20psi), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
sure the water storage tank inside the refrigerator
is properly filled. To do this, press the water
dispenser lever until the water runs from the water
outlet.
Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼” compression nut.
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and ¼” compression nut.
Connecting to the water supply line
1.
supply.
Locate the nearest cold water drinking line and
2.
Connect the water line installation kit to the
3.
Connecting the water supply line to
the refrigerator.
the refrigerator.
There are several items that you need to purchase
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
to complete this connection.
You may find these items sold as a kit at your local
hardware store.
Use Copper Tubing
Use Plastic Tubing
¼” copper tubing
¼” compression nut (1pc)
Ferrule (2pc)
¼” plastic tubing
Molded end(Bulb)
¼” compression nut (1pc)
Pipe clamp
Cold water line
Shut off valve
Shut off valve
Pipe clamp
Cold water line
Water line installation kit
DA68-02601A(EN+FR+ES)-0.2.indb 10
2012.3.31 9:49:43 AM
01
SETTING UP
Pull out the freezer drawer ,then you can
see the lower hinge .
see the lower hinge .
1
2
2.
3. Adjust the height by turning a philips
screwdriver (+) clockwise ( ) or
counterclockwise ( ).
counterclockwise ( ).
3
4
Insert a philips screwdriver (+) into the shaft
of the lower hinge.
of the lower hinge.
3
When you turn a philips screwdriver (+)
counterclockwise ( ), the door will
move up.
counterclockwise ( ), the door will
move up.
1
2
3
4
3
DOWN
UP
UP