Electrolux E30EW85PPS Owner's Manual

Page of 44
32
Setting Oven Controls
Before Starting Clean
Adhere to the following precautions before a clean cycle:
Do not leave small children unattended near the appliance. Dur-
ing self clean the oven may become very hot to the touch. Do not 
touch the oven during the clean cycle.
Do not force the oven door open when clean is active. This can 
damage the automatic door-locking system. Use caution when 
opening the door after cleaning. The oven may still be very hot 
and can cause burns. To avoid possible burns, stand to one side 
of the oven when opening the oven door to allow hot air or steam 
to escape.
The health of some birds is extremely sensitive to fumes given 
off during the clean cycle of any oven. Move birds to another 
well-ventilated room.
Do not line the oven walls, oven racks, oven bottom or any other 
part of the range with aluminum foil. Doing so will stop heat dis-
tribution, produce poor baking results and may cause permanent 
damage to the oven interior. Aluminum foil will melt to a hot oven 
surface during clean. 
Clean any soil from the outer frame, the inside and outside of the 
door, the small area at the front and center of the oven bottom, 
and any areas outside the oven gasket. These areas heat suffi-
ciently to burn on soils. clean using soap and water before 
starting a self clean.
IMPORTANT!  Remove all items from the oven including food, 
cookware, utensils, plastic, and any aluminum foil. Aluminum 
foil will not withstand high temperatures generated during the 
clean cycle and will melt.
Remove any excessive build up caused by spills. Any spill on 
the oven bottom should be wiped up and removed before 
starting a clean cycle. To clean, use hot, soapy water and a 
cloth. Large spill residue can cause heavy smoke or fire when 
subjected to high temperatures. Do not allow food spills with a 
high sugar or acid content (such as milk, tomatoes, sauerkraut, 
fruit juices, or pie filling) to remain on the surface as they may 
leave a dull spot even after cleaning.
Be sure the oven vent is clear. Be sure oven light shield is in 
place.
Do not clean the oven door gasket (
Figure 30
). Do not use any 
cleaning materials on the oven door gasket. Doing so may 
damage the gasket. The woven material of the oven door is 
essential for a good seal. Care should be taken not to rub, 
damage or remove the door gasket.
Do not use commercial oven cleaners or protective coatings of 
any kind inside oven. Residue from oven cleaners may damage 
the porcelain during the next clean cycle.
.
 
Porcelain coated oven racks
This oven comes with lubricated porcelain oven racks, 
which can remain in the oven during the clean cycle. Do not 
clean this vegetable oil lubrication off the racks. It is 
important that the sides of the oven racks always have a 
light coating of vegetable oil. To maintain optimal rack 
performance, re-apply a thin layer of vegetable oil to the 
sides of the rack after every clean cycle or when the rack 
becomes difficult to slide. Refer to 
REMOVE RACKS will flash in the display for several 
seconds as a reminder to remove the racks before starting 
a clean cycle. (
Figure 31
It is recommended to remove 
racks from the oven during clean cycles, but porcelain 
racks may be left in the oven if they are soiled. 
Figure 30: How to clean around oven gasket
Figure 31: Reminder to remove racks before clean cycle