Electrolux E30EW85PPS Owner's Manual

Page of 44
36
Care and Cleaning
General Cleaning
Before manually cleaning any part of the oven, be sure all 
controls are turned off and the oven is cool.
Aluminum Foil and Oven Liners
Do not use oven bottom liners or use aluminum foil to 
cover the oven racks.
Protective liners—Do not use aluminum foil to line the oven 
bottom, except as suggested in the manual. Improper installation 
of these liners may result in a risk of electrical shock, or fire.
Using a liner in the oven restricts the heat and air flow needed 
to obtain the best possible cooking results for any oven.
During clean the oven temperature can become hot enough to 
melt aluminum cooking utensils or aluminum foil if left in the 
oven. This could result in permanent damage to the oven 
interior and porcelain finish.
Replacing the Oven Lights
Replacing the Dual Left and Right Corner Oven Lights
There are two interior oven lights located at the rear of the oven 
cavity and are covered with a glass shield. The glass shield 
must be in place whenever the oven is in use (
).
To replace the oven interior light bulb:
Be sure the oven is unplugged and all parts are cool before 
replacing oven light.Wear a leather-faced glove for protection 
against possible broken glass.
1.
Turn electrical power off at the main source or unplug the 
appliance
2.
Remove interior oven light shield by turning a quarter turn 
counter-clockwise.
3.
Replace bulb with a new T-4 type Halogen 25 watt 
appliance bulb. 
Do not allow your fingers to touch the new bulb when replacing. 
This will shorten the life of the bulb. Use a paper towel or cotton 
glove while handling the new bulb when installing.
4.
Replace glass oven light shield by rotating clockwise.
5.
Turn power back on again at the main source (or plug the 
appliance back in).
6.
Reset the time of day on the clock.
Replacing the Dual Left or Right Side Oven 
Lights
An interior oven light will turn on automatically when the oven 
door is opened. The oven light may be turned on when the door 
is closed by using the oven light switch located on the control 
panel.
The lamp is covered with a glass shield. The glass shield can 
be remove to be cleaned manually or to change the oven light.
To replace the oven interior light bulb:
Be sure the range is unplugged and all parts are cool before 
replacing oven light. Wear a leather-faced glove for protection 
against possible broken glass.
1.
Turn electrical power off at the main source or unplug the 
appliance.
2.
To remove the glass shield, pull the back side of the shield 
toward the inside of the oven in a manner to lift it up from 
the oven side. The glass shield should come out easily by 
pushing a little toward front of the wall oven (See 
).
3.
Replace the Halogen appliance bulb. 
Do not allow your fingers to touch the new bulb when replacing. 
This will shorten the life of the new bulb. Use a paper towel to 
cover the new bulb when installing.
4.
Replace glass interior oven light shield.
5.
Turn power back on again at the main source (or plug the 
appliance back in).
6.
Be sure to reset the time of day on the clock.
Figure 36: Oven light in rear of cavity
Figure 37: Light shield (L) and Halogen bulb (R)
Lift backside of 
glass shield and 
remove it.
Halogen
Light Bulb