Electrolux EW36GC55GB Owner's Manual

Page of 20
14
General Care & Cleaning
caRe & cleaninG table
Surfaces
Painted and Plastic
Control Knobs
Porcelain Enamel
Burner Grates,
Burner Caps
Surface Burners
Burner Head
Stainless Steel
How to Clean
For general cleaning, use hot, soapy water and a cloth. For more difficult soils 
and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil 
for 30 to 60 minutes. Rinse with a damp cloth and dry. 
DO NOT use abrasive 
cleaners on any of these materials; they can scratch.
Clean burner grates in the dishwasher and dry upon removal.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a
1:1 solution of clean water and ammonia. If necessary, cover difficult spots with
an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water 
and a damp cloth, then scrub with a soap-filled scouring pad. Rinse and wipe dry
with a clean cloth. Remove all cleaners or the porcelain may become damaged 
during future heating. 
DO NOT use spray oven cleaners on the cooktop.
The holes in the burners of your cooktop must be kept clean at all times for 
proper ignition and a complete, even flame.
 Clean the burner holes routinely 
with a small gauge wire or needle and especially after bad spillovers which could 
clog these holes.
To  remove,  clean  and  replace  sealed  burner  units;  follow  the  instructions  in 
General Care & Cleaning section under
Cleaning the Burner Grates, Burner
Caps, Burner Heads. For stubborn stains, scrub with soap and water or a mild 
abrasive cleanser and damp cloth. Dry the burners  thoroughly in a warm oven 
for 30 minutes. Then replace them, making sure they are seated and level.
DO
NOT put burner units in the dishwasher.
Clean 
stainless steel with hot, soapy water and a dishcloth. Rinse with 
clean water and a cloth. 
Do not use cleaners with high concentrations
of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only use 
kitchen cleaners that are especially made for cleaning stainless steel. Always 
be sure to rinse the cleaners from the surface as bluish stains may occur 
during heating that cannot be removed.
caRe and cleaninG of stainless steel
Special care and cleaning are 
required for maintaining the appearance of stainless parts. 
Please refer to the table provided at the beginning of the 
General Care & Cleaning 
section in this Use & Care Manual.