Motorola MPC8260 User Manual
MOTOROLA
Chapter 17. Timers
17-7
Part IV. Communications Processor Module
17.2.4 Timer Reference Registers (TRR1ÐTRR4)
Each timer reference register (TRR1ÐTRR4), shown in Figure 17-6, contains the timeoutÕs
reference value. The reference value is not reached until TCNx increments to equal the
timeout reference value.
reference value. The reference value is not reached until TCNx increments to equal the
timeout reference value.
10
OM
Output mode
0 Active-low pulse on TOUTx for one timer input clock cycle as deÞned by the ICLK bits. Thus,
0 Active-low pulse on TOUTx for one timer input clock cycle as deÞned by the ICLK bits. Thus,
TOUTx may be low for one general system clock period, one general system clock/16 period, or
one TINx clock cycle period. TOUTx changes occur on the rising edge of the system clock.
one TINx clock cycle period. TOUTx changes occur on the rising edge of the system clock.
1 Toggle TOUTx. TOUTx changes occur on the rising edge of the system clock.
11
ORI
Output reference interrupt enable.
0 Disable interrupt for reference reached (does not affect interrupt on capture function).
1 Enable interrupt upon reaching the reference value.
0 Disable interrupt for reference reached (does not affect interrupt on capture function).
1 Enable interrupt upon reaching the reference value.
12
FRR
Free run/restart.
0 Free run. The timer count continues to increment after the reference value is reached.
1 Restart. The timer count is reset immediately after the reference value is reached.
0 Free run. The timer count continues to increment after the reference value is reached.
1 Restart. The timer count is reset immediately after the reference value is reached.
13Ð14
ICLK
Input clock source for the timer.
00 Internally cascaded input. For TMR1, the timer 1 input is the output of timer 2. For TMR3, the
00 Internally cascaded input. For TMR1, the timer 1 input is the output of timer 2. For TMR3, the
timer 3 input is the output of timer 4. For TMR2 and TMR4, this selection means no input clock is
provided to the timer.
provided to the timer.
01 Internal general system clock.
10 Internal general system clock divided by 16.
11 Corresponding TINx: TIN1, TIN2, TIN3, or TIN4 (falling edge).
10 Internal general system clock divided by 16.
11 Corresponding TINx: TIN1, TIN2, TIN3, or TIN4 (falling edge).
15
GE
Gate enable.
0 TGATEx is ignored.
1 TGATEx is used to control the timer.
0 TGATEx is ignored.
1 TGATEx is used to control the timer.
Bit
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Field
Timeout reference value
Reset
0xFFFF
R/W
R/W
Addr
Figure 17-6. Timer Reference Registers (TRR1ÐTRR4)
Table 17-3. TMRIÐTMR4 Field Descriptions (Continued)
Bits
Name
Description