Motorola MPC8260 User Manual

Page of 1006
MOTOROLA
Chapter 33.  Serial Peripheral Interface (SPI)  
33-1
Chapter 33  
Serial Peripheral Interface (SPI)
330
330
The serial peripheral interface (SPI) allows the MPC8260 to exchange data between other
MPC8260 chips, the MPC860, the MC68360, the MC68302, the M68HC11 and M68HC05
microcontroller families, and peripheral devices such as EEPROMs, real-time clocks, A/D
converters, and ISDN devices.
The SPI is a full-duplex, synchronous, character-oriented channel that supports a four-wire
interface (receive, transmit, clock and slave select). The SPI block consists of transmitter
and receiver sections, an independent baud-rate generator, and a control unit. The
transmitter and receiver sections use the same clock, which is derived from the SPI baud
rate generator in master mode and generated externally in slave mode. During an SPI
transfer, data is sent and received simultaneously.
Because the SPI receiver and transmitter are double-buffered, as shown in Figure 33-1, the
effective FIFO size (latency) is 2 characters. The SPIÕs msb is shifted out Þrst. When the
SPI is disabled in the SPI mode register (SPMODE[EN] = 0), it consumes little power.
Figure 33-1. SPI Block Diagram
SPI Mode Register
Transmit_Register
Receive_Register
Counter
Shift_Register
SPIBRG
Pins Interface
BRGCLK
SPIMOSI
SPISEL
SPIMISO
SPICLK
TxD
RxD
IN_CLK
60x Bus
Peripheral Bus