Manualsbrain.com
  1. Manuals
  2. Brands
  3. Pelco
  4. C1977M-D
  5. User Manual

Pelco C1977M-D User Manual

Download
Page of 92
[ 76 ] 
      Pelco Manual C1977M-D (6/02)
Connecting PelcoNet To The Com Out RS-422 Port On a
Genex Multiplexer
Refer to Figure 43 and the instructions that follow.
Figure 43.  Connecting PelcoNet to Genex Using the COM OUT RS-422 Port
1. Verify that the multiplexer has Version 4.1 firmware. (The version number flashes on the monitor
when power is applied to the multiplexer.)
2. Set PelcoNet’s transparent data port to 9600 baud, 8 data bits, none (for parity), and 1 stop bit if it is
not so set already. This is the default setting.
3. Create a cable using the diagram in Figure 43.
4. Attach the cable’s DB9 connector end to PelcoNet’s transparent data port. Connect the cable’s RJ-45
connector end to COM OUT on the back of the multiplexer.
5. Connect the MAIN video output from the multiplexer to the PelcoNet transmitter.
6. Connect PelcoNet’s Ethernet port to the network using a Cat5 Ethernet patch cable.
00529