Mitsubishi Electronics FR-A700 User Manual

⋅ Set the PU (FR-DU07/FR-PU07/FR-PU04) to the

jog operation mode. Operation is performed only
while the start button is pressed.

⋅ When Pr. 29 Acceleration/deceleration pattern selection= "1" (S-pattern acceleration/deceleration A), the acceleration/deceleration

time is the period of time required to reach Pr. 3 Base frequency.

⋅ The Pr. 15 setting should be equal to or higher than the Pr. 13 Starting frequency setting.

⋅ The JOG signal can be assigned to the input terminal using any of Pr. 178 to Pr. 189 (input terminal function selection). When terminal

assignment is changed, the other functions may be affected. Set parameters after confirming the function of each terminal.

⋅ During jog operation, the second acceleration/deceleration via the RT signal cannot be selected. (The other second functions

are valid. (Refer to page 235))

⋅ When Pr. 79 Operation mode selection = "4", push 

/

 of the PU (FR-DU07/FR-PU04/FR-PU07) to make a start or push

 to make a stop.

⋅ This function is invalid when Pr. 79 = "3".

⋅ Jog operation is invalid under position control.

♦ Parameters referred to ♦

⋅ Pr. 13 Starting frequency  

⋅ Pr. 29 Acceleration/deceleration pattern selection  

⋅ Pr. 20 Acceleration/deceleration reference frequency, Pr. 21 Acceleration/deceleration time increments  

⋅ Pr. 79 Operation mode selection  

⋅ Pr. 178 to Pr. 189 (input terminal function selection)   

Motor

Inverter

R/L

1

S/L

2

T/L

3

U
V
W

FR-DU07

Three-phase AC 

power supply

1.

2.

 

6.

 

7.

 

8.

  

5.

 

9.

10.

Indication

Operation

Stop

The parameter 
number read 
previously 
appears.

Press        to choose the 

PU JOG operation mode.

3.

 Press        (or        ). 

4.

 Release        (or        ).

The monitor mode should have been selected.

The inverter should be at a stop.

While         (or        ) is pressed, the 

motor rotates.

Rotates at 5Hz. (initial value of Pr. 15)

Hold down.

Press         to set.

Flicker      Parameter setting complete!!

Release

Press         to choose the parameter 

setting mode.

Perform the operations in steps 1 to 4.
The motor rotates at 10Hz.

Turn          until Pr. 15 JOG frequency 

appears.

Turn         to set the value to 

"           ". (10Hz)

Press         to show the present set 

value. (5Hz)

Confirmation of the RUN indicator and 
operation mode indicator