ALTINEX PNP527 User Manual

Page of 12
TABLETOP SOLUTIONS
400-0464-003
2
PRECAUTIONS / SAFETY WARNINGS
1
Please read this manual carefully before using your 
PNP515/517 Interconnect Box. Keep this manual 
handy for future reference. These safety 
instructions are to ensure the long life of your 
PNP515/517
and to prevent fire and shock 
hazards. Please read them carefully and heed all 
warnings.
1.1 GENERAL
Unauthorized personnel shall not open the unit 
since there are high-voltage components inside.
Qualified ALTINEX service personnel, or their 
authorized representatives, must perform all 
service.
1.2 INSTALLATION PRECAUTIONS
For best results, place the PNP515/517 in a dry 
area away from dust and moisture.
To prevent fire or shock, do not expose this unit 
to  water
or moisture. Do not place the 
PNP515/517 in direct sunlight, near heaters or 
heat-radiating appliances, or near any liquid. 
Exposure to direct sunlight, smoke, or steam can 
harm internal components.
Handle the PNP515/517 carefully.  Dropping or 
jarring can damage the unit.
Never place fingers inside the openings  of the 
unit. This action could cause serious injury due 
to sharp edges inside the PNP515/517.
Do not place heavy objects on top of the
PNP515/517. Do not use excessive force to 
push down on the top of the unit.
To turn off the main power, disconnect the 
power cord which powers the AC socket on the 
PNP515/517 pop-up panel. The power outlet 
used should be installed as near to the 
equipment as possible and should be easily 
accessible.
ALTINEX recommends using wall outlets with a 
Ground Fault Circuit Interrupter (GFCI) for 
maximum protection.
Install all cables according to the instructions. Do 
not force or pull out any cable or power cord that 
is attached to the PNP515/517.
1.3 CLEANING
Surfaces should be cleaned with a dry cloth. 
Never use strong detergents or solvents such as 
alcohol or thinner. Do not use a wet cloth or 
water to clean the unit.
1.4 FCC NOTICE
This device complies with Part 15 of the FCC 
Rules. Operation is subject to the following two 
conditions: (1) This device may not cause 
harmful interference, and (2) this device must 
accept any interference received, including 
interference that may cause undesired 
operation.
This equipment has been tested and found to 
comply  with the limits for a Class A digital 
device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable 
protection against harmful interference when the 
equipment is operated in a commercial 
environment. This equipment generates, uses, 
and can radiate radio frequency energy and, if 
not installed and used in accordance with the 
instructions found herein, may cause harmful 
interference to radio communications. Operation 
of this equipment in a residential area is likely to 
cause harmful interference in which case the 
user will be required to correct the interference 
at his expense.
Any changes or modifications to the unit not 
expressly approved by ALTINEX, Inc. could void 
the user’s authority to operate the equipment.