Honeywell DR4300 User Manual

The configuration prompts are sequenced in a group/function hierarchy as shown in Figure 4-2. Once you 
have set the input switches in SW6 as described in Subsection 4.3.5, configure all the function parameters 
that are applicable for your recorder model and application. During configuration some function 
parameters will not be displayed if they do not apply to your application. For example, if you set the 
control group function “CONTRL” to “DIS”, disabling control, then no other control group prompts will 
be displayed.  

To enter your selections or values, follow the procedure in Table 4-4 and fill in the values or selections on 
the worksheet in Subsection 4.3.21. Keep this worksheet as a record of how your recorder was configured. 

This procedure tells you the keys to press to get to any set up group (and any associated function 
parameters prompt). 

Follow the procedure listed in Table 4-4 to access the set up groups and function prompts. If you have a  
2-pen recorder, be sure to identify individual parameters for each pen and control loop as applicable. 

Make sure lock set up group “LOCK” function is set to “NONE” or “CAL.” See Subsection 4.3.19. 

 

Select Set Up mode 

 

  SET

Upper Display

Lets you know you are in the 

configuration mode and a set up group 
title is being displayed in the lower 
display. 

INPUT

Lower Display

This is the first set up group title. 

Select any set up group 

 

•  Successive presses of the  SET UP  key will display 

the other set up group titles shown in the prompt 
hierarchy in Figure 4-2. 

•  You can also use the [

▲] [▼] keys to scan the set up 

groups in both directions. 

•  Stop at the set up group title which describes the 

group of parameters you want to configure. Then 
proceed to the next step. 

Select a function parameter 

 

Upper Display

xxxx

Shows the current value or selection for 

the first function prompt of the set up 
group that you have selected. 

DECMAL

Lower Display

Shows the first function prompt within 

the selected set up group. 

Example displays show Input group function prompt 
“DECMAL” and the value selected.