Multi-Tech Systems MVP2400 User Manual

The procedures “Phone/IP Starter Configuration” and “Phonebook
Starter Configuration” must be completed before you can do this
procedure.

1. These connections must be made:

MultiVOIP to local PBX

MultiVOIP to local phone
station
 –OR--
MultiVOIP to extension of
key phone system

MultiVOIP to command PC

MultiVOIP to command PC

MultiVOIP to Internet

MultiVOIP to Internet

2. Inbound Phonebook and Outbound Phonebook must both be set up

with at least one entry in each.  These entries must allow for
connection between two voip units.

3. Console messages must be enabled.  (If this has not been done

already, go, in the MultiVOIP GUI, to Configuration | Logs and
select the “Console Messages” checkbox.

4. You now need to free up the COM port connection (currently being

used by the MultiVOIP program) so that the HyperTerminal program
can use it.  To do this, you can either (a) click on Connection in the
sidebar and select “Disconnect” from the drop-down box, or (b) close
down the MultiVOIP program altogether.

5. Open the HyperTerminal program.