AMX RE-DM4 User Manual

AMX RADIA Lighting Programming

46

 RE-DM4 and RE-DM6 RADIA Eclipse Dimmer Modules

Set Curve

This function sets the specified dimmer(s) to follow the specified curve.

Curve Status (NEW)

This function returns the curves assigned to each dimmer. The response will be an incoming COMMAND to 
the master.

Set Low End (NEW)

This function sets the minimum on percentage for the specified dimmer (i.e. a level of 0 will still be off). 

For example, if the low end is set to 10, then any request for a level between 1-10 will result in the output level 
being 10; a request for 0 will be 0; a request for a level between 11-100 will result in the outputting of that 
level. 

This function is used to prevent certain loads from dimming below the product's ability.

Low End Status (NEW)

This function returns the low end settings assigned to each dimmer. The response will be an incoming 
COMMAND to the master.

Reboot (NEW)

This function reboots the dimmer and initializes it to its power-up state. The device will go off-line and then 
return on-line with the master controller.

Set Curve

Command:

Response:

None

Examples:

Set dimmer 1 to curve 1

Set dimmers 1-4 to curve N

Set all dimmers to curve 3

Curve Status

Command:

Response:

?C-<curve1>,<curve2>,<curve3>,<curve4>,<curve5>,<curve6>

Example:

Request current curve settings

Response: 'C-1,1,1,1,N,N'

Set Low End

Command:

Response:

None

Example:

Set minimum level of dimmer 2 to 20%

Low End Status

Command:

Response:

LE-<percent1>,<percent 2>,<percent 3>,<percent 4>,<percent 5>,<percent 6>

Example:

Request current low end settings

Response: 'LE- 000, 005, 000, 000, 005, 000'

Reboot

Command:

Response:

None

Example:

Reboot dimmer