Black Box 10BASE-T/100BASE-TX G.SHDSL Two-Wire Extender/NTU User Manual

 724-746-5500   |   blackbox.com

Page 30

Black Box G.SHDSL.bis EFM CPE

Remote control session diagram

The following steps are to establish a connection to the remote LB510A-R2 (far-end) 
via Remote Console Session (RCS):

   1. Connect to the console port of the LB510A-R2 (near-end) via Telnet session.

   2. At the password prompt, log in to the near-end LB510A-R2. 

   3. Ensure that a DSL link is established. You can verify an established DSL link by 

using the system show status command or by checking that the DSL LED is solid 
green. Upon executing the show status command, the dsl link state is shown as 
success if the DSL link is established.

   4. At the command prompt, enter the command remote console.

   5. Wait for the message Console: Remote console connection established.

-If a DSL link is not established, or for some other reason the LB510A-R2 (far-
end) does not respond in a reasonable amount of time, the following message 
appears: Console: Remote console timed out trying to connect. Enter the com-
mand remote console again.

-If LB510A-R2 (Far End) already has an active remote console session open, you 
will see the message Console: Remote console connection request rejected. This 
can also happen if the remote LB510A-R2 (far-end) has an established remote 
console session with the local LB510A-R2 (near-end) which has timed out.

   6. Enter the password at the password prompt for the remote console session.