Sony 8000SF User Manual

238

Multi Program 2

Cha

For details, see “Cross-Point Settings (Xpt Assign Menu)” in Chapter 16
(Volume 2).

Enabling DME wipe operations for sub

By factory default, DME wipe operations are inhibited for sub background. To
enable them, in the Engineering Setup >Switcher >Config menu, set [DME
Wipe Sub Enable] to On.
This enables DME wipe operations for sub background.
This setting applies to the whole control panel (all M/E banks and PGM/PST
bank).

Note

If a DME wipe for sub is recalled in a snapshot or keyframe, the image will not
be handled correctly.

Inhibiting utility 2 bus signal selection

In Multi Program 2 mode, you can inhibit other uses of the utility 2 bus signal
in order to use the signal as the background for sub.
This setting applies to the whole control panel (all M/E banks and PGM/PST
bank).
In the Engineering Setup >Panel >Config >MP2 Main/Sub Assign menu, set
[Util2 Inhibit] to On.
This inhibits operations of selecting from the background B row while holding
down the [UTIL] button in the cross-point control block.

Including Multi Program 2 data in recall operations of keyframes
and snapshots

In the Engineering Setup >Switcher >Config menu, set [Recall M/E Config] to
On.
When a keyframe or snapshot is stored or recalled, the following data is
included.

M/E Config, PGM Config, M/E Output Assign, and Key PVW Config

For details of the above data, see “Setting the operating mode for each
switcher bank” (page 233) and “Assigning output signals for Multi Program
2 mode” (page 233).

This setting applies to the whole control panel (all M/E banks and PGM/PST
bank).

Note

M/E Config data is saved, even when this setting is Off.