GarrettCom Magnum 6K32T User Manual

Magnum 6K32 & 6K32T Managed Switch Installation and User Guide (12/05)

www GarrettCom com

Step 4. Hold the daughter board with both hands at the end and align the two cream

color latching

connectors (male)

placed at the bottom of

the daughter board

with the other female

connector placed on

the Granddaughter and

main board. As shown

above in Fig. 3.5.2e

Step 5. Once the

latching connectors are aligned properly and the mounting holes are aligned

with stand offs then press slowly and firmly with two fingers (as shown below

in Fig. 3.5.2f) on the top of the latching connectors until the connectors latched

Fig.3.5.2f: Securely latching up 6KPM Cards into a Magnum 6K32T & 6K32

NOTE:. When leaving 6KPM slots empty, always use a face plate (Magnum 6K8-

BLNK) to cover the slot opening in the front panel. This will maintain proper cooling

air flow, safety, and operation as required by FCC, CE, and other regulations.

Step 6. Now screw down the daughter board with 7 #440 screws except the last two at

the end, so that it holds the daughter board securely. The figure below shows the

top view of 6KPM card after successfully installing the 6KPM cards inside the

Magnum 6K32T.

Fig. 3.5.2g Top View :

6KPM Module installed

inside a 6K32T Switch

Step 7. Once the installation of granddaughter and daughter modules is done properly,

the front panel screen plates(come along with the 6K-module) need to be properly placed

on the front of the chassis cover to complete the installation process.