DELL PC7024 User Manual
IP Addressing Commands
513
Use the no form of the command to remove a specific address or to return the
address assignment to its default value. Using the no form of the command
with no parameters removes all IPv6 prefixes from the interface.
Syntax
ipv6 address {
prefix/prefix-length [eui64] | autoconfig | dhcp }
no ipv6 address {
prefix/prefix-length [eui64] | autoconfig | dhcp }
Parameter Description
Default Configuration
No address is assigned to the out-of-band interface by default.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
When DHCPv6 is enabled on the Out-of-Band interface, the system
automatically deletes all manually configured IPv6 addresses on the interface.
DHCPv6 can be enabled on the Out-of-Band interface only when IPv6 auto
DHCPv6 can be enabled on the Out-of-Band interface only when IPv6 auto
configuration or DHCPv6 is not enabled on any of the in-band management
interfaces.
IPv6 auto configuration mode can be enabled in the Out-of-Band interface
IPv6 auto configuration mode can be enabled in the Out-of-Band interface
only when IPv6 auto configuration or DHCPv6 is not enabled on any of the
in-band management interfaces.
Parameter
Description
prefix
An IPv6 prefix in global format address format.
eui64
Formulate the prefix in EUI-64 format.
autoconfig
Perform IPv6 auto-configuration.
dhcp
Obtain the prefix via DHCP.
2CSPC4.XCT-SWUM2XX1.book Page 513 Monday, October 3, 2011 11:05 AM