Cabletron Systems 6E133-25 User Manual

The following section explains each field of the Ethernet Full Duplex 
Configuration screen.

PORT # (Read-only)

Identifies the number of the port.

OPERATION MODE (Toggle)

Allows the user to set the specified port to transmit and receive data 
separately or simultaneously. Set this field to one of the following values:

STANDARD ENET – The port is running at 10 Mbps (default) and 
either transmits data or receives data, but not both at the same time. To 
set Ethernet ports for Full Duplex operation, refer to 

FULL DUPLEX – The port transmits and receives data at the same 
time (full duplex) and operates at 20 Mbps. To set Ethernet ports for 
Full Duplex operation, refer to 

LINK STATUS (Read-only)

Indicates whether there is a physical connection from this port to another 
Ethernet device. One of the following values displays:

Link – There is a valid link signal present; there is a valid physical 
connection from this port to another device.

No Link – There is no valid link signal present; there is no valid 
physical connection from this port to another device.

PORT STATUS (Read-only)

Indicates whether the port was turned on or off administratively. One of 
the following values is displayed:

ENABLED – The port is turned on administratively.

DISABLED – The port is turned off administratively.

SET ALL PORTS (Toggle)

Ports 1 through 24 can be set all at once to either STANDARD or FULL 
from this field. To set all ports, refer to 

.

Enabling or disabling ports from the Switch Configuration 
screen is described in