DELL N3000 User Manual
Configuring DHCPv6 Server and Relay Settings
1277
Configuring the DHCPv6 Server and Relay (CLI)
This section provides information about the commands you use to configure
and monitor the DHCP server and address pools. For more information about
the commands, see the
Dell Networking N2000, N3000, and N4000 Series
Switches CLI Reference Guide at
.
Configuring Global DHCP Server and Relay Agent Settings
Beginning in Privileged EXEC mode, use the following commands to
configure settings for the DHCPv6 server.
Configuring a DHCPv6 Pool for Stateless Server Support
Beginning in Privileged EXEC mode, use the following commands to create a
pool and configure pool parameters for DHCPv6 clients that obtain IPv6
network information dynamically.
Command
Purpose
configure
Enter Global Configuration mode.
service dhcpv6
Enable the DHCPv6 server.
ipv6 dhcp relay-agent-
info-opt
option
Configure a number to represent the DHCPv6 Relay
Agent Information Option.
The
The
option
parameter is an integer from 54–65535.
ipv6 dhcp relay-agent-
info-remote-id-subopt
suboption
Configure a number to represent the DHCPv6 remote-ID
sub-option
The
The
suboption
parameter is an integer from 1–65535.
exit
Exit to Privileged EXEC mode.
show ipv6 dhcp
Verify the global DHCPv6 server configuration.
Command
Purpose
configure
Enter Global Configuration mode.
ipv6 dhcp pool
name
Create a DHCPv6 pool and enter DHCPv6 pool
configuration mode.
dns-server
ipv6-address
Set up to eight IPv6 DNS server addresses to provide to a
DHCPv6 client by the DHCPv6 server.