Zebra Technologies 105SL Plus User Manual
Troubleshooting
Calibration Problems
Calibration Problems
144
P1056468-002
105SLPlus™ User Guide
7/3/13
Calibration Problems
identifies problems with calibration, the possible causes, and the recommended
solutions.
Table 16 • Calibration Problems
Problem
Possible Cause
Recommended Solution
Loss of printing
registration on labels.
Excessive vertical
drift in top-of-form
registration.
registration on labels.
Excessive vertical
drift in top-of-form
registration.
The platen roller is dirty.
Media guides are positioned
improperly.
improperly.
Ensure that the media guides are properly
positioned.
positioned.
The media type is set
incorrectly.
incorrectly.
Set the printer for the correct media type
(non-continuous or continuous) See
(non-continuous or continuous) See
.
The media is loaded incorrectly
or the media sensor is
positioned improperly.
or the media sensor is
positioned improperly.
Reload the media and ensure that the sensor in
use is properly positioned. See
use is properly positioned. See
Auto Calibrate failed.
Media or ribbon is loaded
incorrectly.
incorrectly.
Ensure that media and ribbon are loaded
correctly.
correctly.
The sensors could not detect the
media or ribbon.
media or ribbon.
Calibrate the printer. See
.
The sensors are dirty or
positioned improperly.
positioned improperly.
Ensure that the sensors are clean and properly
positioned.
positioned.
The media type is set
incorrectly.
incorrectly.
Set the printer for the correct media type
(non-continuous or continuous) See
(non-continuous or continuous) See
.