ZyXEL Communications P-202H Plus v2 User Manual
P-202H Plus v2 Quick Start Guide
3
4 POWER: Use the power adaptor provided with your P-202H Plus v2 to connect an appropriate power
source to this port. Make sure the power source is on.
5 Push in the POWER button. Look at the LEDs on the front panel.
• The POWER LED blinks while your P-202H Plus v2 starts up and stays on once the system is ready.
• The ISDN and ETHERNET LEDs stay on if the corresponding port is properly connected and blinks when there
• The POWER LED blinks while your P-202H Plus v2 starts up and stays on once the system is ready.
• The ISDN and ETHERNET LEDs stay on if the corresponding port is properly connected and blinks when there
is traffic.
If any of these LEDs are not on, check your connections, and inspect your cables for damage. If the LEDs are
still off, contact your local vendor.
still off, contact your local vendor.
3 Initial Configuration
1 Open your web browser, and go to
http://192.168.1.1
.
2 The login screen displays. Enter the password (“1234” is the default) and click Login.
Note: If the login screen does not display, check your browser’s security settings (see
Troubleshooting for details) or make sure your computer is set to receive an IP address
dynamically (see
dynamically (see
Set Up Your Computer’s IP Address
).
3 Type a new password, re-type it to confirm, and click Apply. (The next time you log in, you should not see
this screen.
4 You should now see the Site Map screen.