Q-Logic 6140 User Manual
B – Configuring CHAP
Configuring CHAP Using CLI
Configuring CHAP Using CLI
B-2
FI0154601-00 C
S
2.
Use the initiator add command to add the initiator that is about to do
discovery:
a.
Enable the CHAP for this initiator.
b.
Create a secret (for example, secret_initiator).
c.
Use the set chap command to update the CHAP settings of the
initiator.
3.
Go to the Microsoft iSCSI (MS) Initiator and perform the following steps:
a.
Click General.
b.
Click Secret (in the middle of the screen). If this is the first time you are
setting secrets, reset all secrets.
setting secrets, reset all secrets.
c.
Type the secret (secret_port) that you created in
.
4.
Click Discovery.
5.
Click Add.
6.
Type the address of the iSCSI port of the router.
7.
Click Advanced.
8.
Select Chap Login Information.
9.
Type the secret (secret_initiator) you created in
into Target Secret.
10. Select Mutual Authentication.
11.
Click OK.
12. Click OK. The initiator completes the discovery.
CLI—Discovery Session—Uni-directional CHAP
To configure a single-direction CHAP used during a discovery session:
1.
Do not enable CHAP on the ISCSI port.
2.
Use Initiator add:
a.
Add the initiator that is about to perform the discovery.
b.
Enable the CHAP for this initiator.
c.
Create a secret (for example, secret_initiator).
d.
Use Set Chap to update the initiator’s CHAP settings.
3.
Go to the MS Initiator.
4.
Click Discovery.
5.
Click Add.