Q-Logic 6140 User Manual
5 – Diagnostics and Troubleshooting
LED Blink Patterns
FI0154601-00 C
5-3
A
LED Blink Patterns
The heartbeat and system fault LEDs show the operational status of the router.
When the POST completes with no errors, these LEDs blink at a steady rate of
once per second. When the router is in maintenance mode, the heartbeat and
system fault LEDs are on continuously.
When the POST completes with no errors, these LEDs blink at a steady rate of
once per second. When the router is in maintenance mode, the heartbeat and
system fault LEDs are on continuously.
All other
system fault
blink patterns show critical errors. The heartbeat LED shows
an error blink pattern for the conditions listed in
Heartbeat Blink Pattern
A blink pattern on the heartbeat LED of one second ON followed by one second
OFF means that the router is operating normally. The heartbeat LED shows this
pattern when the router firmware is operational
OFF means that the router is operating normally. The heartbeat LED shows this
pattern when the router firmware is operational
.
System Error Blink Pattern
The system fault LED generates a three-blink pattern (once per second) followed
by a two second pause to indicate a system error.
by a two second pause to indicate a system error.
Table 5-1. System Fault LED Blink Patterns
System Fault LED
Condition
OFF
OK - Operational
3 Blinks, followed by pause
System error
4 Blinks, followed by pause
Management port IP address conflict
5 Blinks, followed by pause
Over temperature