RAD Data comm Modular Access Device with Integrated Router User Manual
Chapter 4 Configuration
FCD-IPM Installation and Operation Manual
4-6
Quick Setup Menu
Quick Setup for E1 (PPP, IP) + ISDN (Backup, 128K, PPP, IP)
shows the Quick Setup menu for E1.
QUICK SETUP
-----------
WARNING: This device automatically exits to Operational
Messages 10 minutes after last keyboard action without
saving parameters
'ENTER' - Accept parameter , 'SPACE' - Change parameter.
WAN interface Link 1 - E1
Link status
: [Enable]
Link mode
: [Synchronous]
Routing
: [IP ROUTER], Protocol: [PPP]
WAN IP address
: 10.0.0.1, enter new : 10.0.0.1
WAN IP mask
: 255.255.255.252, enter new: 255.255.255.252
Do you want to configure the E1 Interface parameters (Y/N)?:
WAN interface Link 2/CH1 – BRI
Link status
: [Backup] to interface: [LINK 1]
Routing
: [IP ROUTER], Protocol: [PPP]
WAN IP address
: 0.0.0.0, enter new : 0.0.0.
Protocol
: [ETSI]
Bandwidth
: [128]
Connection Type
: [Originate only]
Channel A – Destination phone number: 1234
Channel B – Destination phone number: 5678
Connection
: [Always]
Host IP setup:
LAN Status
: [Enable]
LAN IP address : 192.168.1.1, enter new : 192.168.1.1
LAN IP mask : 255.255.255.000, enter new : 255.255.255.000
Default gateway setting by: [Interface]
Default gateway interface: [LINK 1]
SECURITY Setup
Device access name : FCD-IPM
No password at present – do you want to create password (Y/N)?: [N]
Security type: [Disabled]
Saving the changes might cause the unit to RESET.
Do you want to save QUICK SETUP (Y/N) ? N
Figure 4-3. E1 Interface Quick Setup Screen