Siemens 6500 Series User Manual
6
Chapter 2
Installation
This chapter covers the physical installation of the SpeedStream Gateway.
Minimum System Requirements
• DSL service and an Internet access account from an Internet Service Provider (ISP).
• Network cables for each device you intend to connect to the Gateway.
• TCP/IP network protocol must be installed on all computers.
• For USB connection to the Gateway, the following operating systems are supported:
• Network cables for each device you intend to connect to the Gateway.
• TCP/IP network protocol must be installed on all computers.
• For USB connection to the Gateway, the following operating systems are supported:
• Windows 98, 98SE
• Windows
• Windows
2000
• Windows ME or XP
• Mac OS versions 8.6 through 10.2.4
• Mac OS versions 8.6 through 10.2.4
Note: Your configuration may vary slightly from the instructions and illustrations in this chapter. Refer to
your service provider’s documentation, or contact them with questions regarding your specific
configuration.
your service provider’s documentation, or contact them with questions regarding your specific
configuration.
Hardware Installation
You may position the SpeedStream Gateway at any convenient location in your office or home. No
special wiring or cooling requirements are needed; however, you should comply with the safety guidelines
specified in the
special wiring or cooling requirements are needed; however, you should comply with the safety guidelines
specified in the
section.
Basic Installation Procedure
1.
y.
2.
.
3.
.
4.
5.
6. Reboot the computer if prompted. Whenever you are required to reboot the Gateway, allow five
seconds between turning off the unit and powering it back on.
2