Multi-Tech Systems MT3410ZLX User Manual

C:

You may be using a non-streaming protocol,
like Xmodem or Ymodem to transfer files.
Those are fine unless you are using V.42bis or
MNP5

S:

When using V.42bis or MNP5, you should use a
streaming transfer protocol like Ymodem-G or
Zmodem.

S:

Configure your software to use hardware flow
control (RTS/CTS ON).

C:

The modem defaults to report the modem-to-
computer baud rate when it responds with
CONNECT.

S:

Go to Command mode with your
communication program (like Telix) and type
ATW2, then press Enter. This tells the modem
to report the modem-to-modem baud rate
instead.

C:

Your computer does not have enough memory
to map the attribute memory of your
MT3410ZLX.

S:

If memory management software (e.g.,
EMM386) is installed, you must reserve an area
in upper memory (C000:0 — EFFF:F) for
MT3410ZLX  attribute memory when enabling
the card.