Multi-Tech Systems MT3410ZLX Manuale Utente
MultiMobile Owner’s Manual
44
When Using V.42bis or MNP5, Some Features
Are Disabled
Are Disabled
C:
You may be using a non-streaming protocol,
like Xmodem or Ymodem to transfer files.
Those are fine unless you are using V.42bis or
MNP5
like Xmodem or Ymodem to transfer files.
Those are fine unless you are using V.42bis or
MNP5
S:
When using V.42bis or MNP5, you should use a
streaming transfer protocol like Ymodem-G or
Zmodem.
streaming transfer protocol like Ymodem-G or
Zmodem.
S:
Configure your software to use hardware flow
control (RTS/CTS ON).
control (RTS/CTS ON).
When Connecting to Another Modem, the
Modem Reports a Higher Connect Baud Rate
than it Is Really Using
Modem Reports a Higher Connect Baud Rate
than it Is Really Using
C:
The modem defaults to report the modem-to-
computer baud rate when it responds with
CONNECT.
computer baud rate when it responds with
CONNECT.
S:
Go to Command mode with your
communication program (like Telix) and type
ATW2, then press Enter. This tells the modem
to report the modem-to-modem baud rate
instead.
communication program (like Telix) and type
ATW2, then press Enter. This tells the modem
to report the modem-to-modem baud rate
instead.
When I Run CARDEN, “PC-Card Is Not Enabled
Successfully” Is Displayed
Successfully” Is Displayed
C:
Your computer does not have enough memory
to map the attribute memory of your
MT3410ZLX.
to map the attribute memory of your
MT3410ZLX.
S:
If memory management software (e.g.,
EMM386) is installed, you must reserve an area
in upper memory (C000:0 — EFFF:F) for
MT3410ZLX attribute memory when enabling
the card.
EMM386) is installed, you must reserve an area
in upper memory (C000:0 — EFFF:F) for
MT3410ZLX attribute memory when enabling
the card.