ZyXEL Communications P-2602 User Manual

P-2602H(W)(L)-DxA Series User’s Guide

310

Chapter 25 Tools

The following is an example TFTP command:

tftp [-i] host get rom-0 config.rom

where “

i

” specifies binary image transfer mode (use this mode when transferring binary files), 

“

host

” is the ZyXEL Device IP address, “

get

” transfers the file source on the ZyXEL Device 

(

rom-0

, name of the configuration file on the ZyXEL Device) to the file destination on the 

computer and renames it config.rom.

The following table describes some of the fields that you may see in GUI-based TFTP clients.

to read about configurations that disallow TFTP and FTP 

over WAN.

This section shows you how to restore a previously saved configuration. Note that this 
function erases the current configuration before restoring a previous back up configuration; 
please do not attempt to restore unless you have a backup configuration file stored on disk.  

FTP is the preferred method for restoring your current computer configuration to your device 
since FTP is faster. Please note that you must wait for the system to automatically restart after 
the file transfer is complete.

Table 122   General Commands for GUI-based TFTP Clients

Host

Enter the IP address of the ZyXEL Device. 192.168.1.1 is the ZyXEL Device’s default IP 

address when shipped.

Send/Fetch

Use “Send” to upload the file to the ZyXEL Device and “Fetch” to back up the file on your 

computer. 

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom 

extension) on your computer.

Remote File This is the filename on the ZyXEL Device. The filename for the firmware is “ras” and for 

the configuration file, is “rom-0”.

Binary

Transfer the file in binary mode.

Abort

Stop transfer of the file.