ZyXEL Communications P-2602 User Manual

P-2602H(W)(L)-DxA Series User’s Guide

Chapter 25 Tools

311

Note: WARNING!

Do not interrupt the file transfer process as this may PERMANENTLY 
DAMAGE YOUR device. When the Restore Configuration process is complete, 
the device will automatically restart.

Figure 181   Restore Using FTP Session Example

 to read about configurations that disallow TFTP and FTP 

over WAN.

This section shows you how to upload firmware and configuration files. 

Note: WARNING!

Do not interrupt the file transfer process as this may PERMANENTLY 
DAMAGE YOUR device. 

FTP is the preferred method for uploading the firmware and configuration. To use this feature, 
your computer must have an FTP client. The following sections give examples of how to 
upload the firmware and the configuration files.

1 Launch the FTP client on your computer.

2 Enter “open”, followed by a space and the IP address of your device.  

3 Press [ENTER] when prompted for a username.

4 Enter your password as requested (the default is “1234”).

5 Enter “bin” to set transfer mode to binary.

6 Use “put” to transfer files from the computer to the device, for example, “put 

firmware.bin ras” transfers the firmware on your computer (firmware.bin) to the device 
and renames it “ras”. Similarly, “put config.rom rom-0” transfers the configuration file 
on your computer (config.rom) to the device and renames it “rom-0”. Likewise “get rom-

ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit