IBM 09-0572-000 User Manual

■

Make sure a lobe cable is properly connected to the adapter 
and that the other end of the cable is connected to a DAU, 
MAU, or CAU.

■

Run the test three times with a delay of at least 30 seconds 
between each test. If the error persists, power down the PC 
and try once more. 

■

Make sure a lobe cable is properly connected to the adapter. 
For an adapter with UTP cabling, the other end of the cable 
needs to be connected to a MAU.

■

Try another shared RAM address and size. 

■

Run the test three times with a delay of at least 30 seconds 
between each test. If the error persists, power down the PC 
and try once more. 

If the diagnostic tests fail, the adapter may not be defective. 
The problem may be incorrect option settings or option 
settings that conflict with the settings of other boards, or 
the adapter may be improperly installed. Follow these steps 
to test the adapter further.

CAUTION: Make sure that you turn off the power before 
inserting or removing the adapter from the PC.

1 Make sure that the 3C619C adapter is installed in a UL-listed 

PC containing an ISA or EISA bus. 

2 Make sure that the board is seated firmly and all the way 

down in the slot. Check the adapter installation by 
reviewing the installation instructions in Chapter 2. 

3 Inspect all cables and connections.