Lantronix 1-T2 User Manual

Using the MSS

Multihost Mode

5 - 13

5.4.1 Configuring Multihost Mode

To conÞgure the MSS for multihost mode, Þrst set the MSS for a dedicated
multihost connection using the Change Dedicated Hostlist command.

Figure 5-15:

Setting the MSS for Multihost Mode

NOTE:

When a dedicated connection is enabled, local mode hotkeys for
session manipulation are disabled.

Next, conÞgure the list of hosts with which to communicate using the Host
Add

command. The host list can include up to 12 host entries in any

combination of LAT, SPX, Telnet, Rlogin, and UDP addresses. For more
information about formatting host list entries, see the Host command on page
4-28.

Figure 5-16:

Adding Entries to the Host Table

In the previous example, the UDP host entry is actually a broadcast IP
address. Data would be sent to all hosts on that particular subnet.

NOTE:

Any changes to the host table don't take effect until the port is
logged out or the MSS is initialized.

To remove an entry from the host table, use the Show Hostlist command to
Þnd out its entry number, and then use the Host Delete command.

Figure 5-17:

Removing Entries from the Host Table

Local>> CHANGE DEDICATED HOSTLIST

Local>> HOST ADD LAT commserv

Local>> HOST ADD SPX

sap_name

Local>> HOST ADD TCP 192.0.1.35:T

Local>> HOST ADD UDP 192.0.2.255

Local>> LOGOUT PORT 1

Local>> SHOW HOSTLIST

Local>> HOST DELETE 2

Local>> LOGOUT PORT 1