ZyXEL Communications n/a User Manual

Chapter 21 WAN Commands

DSL & IAD CLI Reference Guide

wan node backup pppopt com <yes|no>

Activates or deactivates PPP compression on the 
previously-specified WAN backup node.

wan node backup pppopt encap 

<std|cisco>

Sets the PPP encapsulation mode of the previously-
specified WAN backup node.

std

: standard PPP encapsulation.

cisco

: Cisco PPP encapsulation.

wan node backup priph <primary-

phone#>

Specifies the phone number the ZyXEL Device 
should call in order to make a connection to the 
previously-specified backup WAN node.

wan node backup private <yes|no>

Specifies whether the previously-specified WAN 
backup node is private or not.

wan node backup remoteip <ip-

address> <subnet mask>

Sets the remote gateway IP address and subnet 
mask of the previously-specified WAN backup node.

wan node backup rip 

<none|in|out|both>

Sets the Routing Information Protocol (RIP) mode 
and type of the previously-specified WAN backup 
node.

wan node backup script set <1~6> 

<expect> <send>

Configures the specified PPP chat script to transmit 
the defined send string when it receives the defined 
expect

 string.

For example, the command:

wan node backup set 2 123 456

 

sets script 2 to transmit “456” when it receives 
“123”.

Note: Use the wan node index 9 

command to specify the backup 
WAN node.

wan node backup secph <secondary-

phone#>

Specifies the backup phone number the ZyXEL 
Device should call in order to make a connection to 
the previously-specified backup WAN node.
The ZyXEL Device calls this number if the primary 
phone number is busy or does not answer.

wan node backup wanip <static <ip-

address>|dynamic> 

Sets the WAN IP address and mode (static or 
dynamic) of the previously-specified WAN backup 
node.

wan node bridge <on|off>

Activates or deactivates bridge mode on the 
previously-specified WAN node profile.

wan node bridgetimeout <minutes>

Type the time (in minutes) for the ZyXEL Device to 
retain the Ethernet address information in its internal 
tables while the line is down. If this information is 
retained, your ZyXEL Device will not have to 
recompile the tables when the line comes back up.

wan node callsch <set#1> <set#2> 

<set#3> <set#4>

Sets the call scheduling profile(s) used by the 
previously-specified WAN node profile.
Use the wan callsch commands to configure call 
scheduling profiles.

wan node clear

Returns the WAN node you previously specified 
with the wan node index <node#> command to 
its defaults.

wan node disable

Deactivates the previously-specified WAN node 
profile.

Table 66   wan node Commands (continued)