ZyXEL Communications n/a User Manual

 Chapter 21 WAN Commands

DSL & IAD CLI Reference Guide

Use these commands to configure the WAN ISP and backup nodes.

Table 66   wan node Commands

wan node backup <enable|disable>

Activates or deactivates the  backup WAN node. 

Note: Use the wan node index 9 

command to specify the backup 
WAN node.

wan node backup filter 

<incoming|outgoing> <profile> 

Sets the filter action and profile to be used by the 
previously-specified WAN backup node.

incoming

: the filter applies to traffic coming from 

the WAN to the LAN.

outgoing

: the filter applies to traffic coming from 

the LAN to the WAN.

: profile number 1 ~ 4. Use the sys 

filter set 

commands to configure filter profiles.

wan node backup idletimeout 

<seconds>

Sets the idle timeout for the previously-specified 
WAN backup node. 

wan node backup ispname <name>

Sets the ISP name for the previously-specified WAN 
backup node.

wan node backup metric <metric>

Sets the metric value (number of transmission hops) 
for the previously-specified WAN backup node.

wan node backup multicast 

<none|igmpv1|igmpv2>

Sets the multicast mode of the previously-specified 
WAN backup node.

wan node backup nailedup <on|off>

Activate or deactivate a nailed-up (always on) 
connection for the previously-specified WAN backup 
node.

wan node backup nat <off|sua|full 

<address mapping rule #>>

Sets the Network Address Translation (NAT) mode 
of the previously-specified WAN backup node.

<off>

: NAT is not active

<sua>

: Use Single User Account only (if you have 

just one public WAN IP address for your ZyXEL 
Device).

<full>

 : Use full-feature NAT (if you have multiple 

public WAN IP addresses for your ZyXEL Device).

<address mapping rule #>

 : When you choose 

full-feature NAT, specify the address mapping rule 
to apply. Use the ip nat addrmap rule 
command to configure address mapping rules.

wan node backup ppp authen 

<chap|pap|both>

Sets the authentication method for the backup WAN 
node (use the wan node index 9 command to 
specify the backup WAN node).

wan node backup ppp idletime 

<seconds>

Sets the PPP idle timeout for the previously-
specified backup WAN node.

wan node backup ppp password 

<password>

Sets the password for the previously-specified 
backup WAN node.

wan node backup ppp username <name>

Sets the username for the  backup WAN node (use 
the wan node index 9 command to specify the 
backup WAN node).