Barco 26-0405000-00 User Manual
PresentationPRO-II • User’s Guide
25
3. Hardware Installation
Installation
fåëí~ää~íáçå
The figure below illustrates a block diagram of a basic PresentationPRO-II system. This
diagram can be used as reference in the following installation procedure.
diagram can be used as reference in the following installation procedure.
Figure 3-1. Block Diagram, Basic PresentationPRO-II System
You will need:
Use the following steps to install PresentationPRO-II:
1. Follow the unpacking procedures as listed in the “
section on page 22.
2. As required, refer to the “
” section on
page 124 in Appendix A for electrical and mechanical details.
3. As required, refer to the “
” section on page 12 in
Chapter 2 for the locations of all connectors.
Ethernet Hub / Switch
Program Out (Analog)
Program Out (Digital)
Inputs
Projector
Program
To External
Controller
Controller
Ethernet
(Optional)
Analog Sources to Analog Inputs 1-8
SD-SDI Source to SDI Input (SDI Model)
SD-SDI/HD-SDI Source to SDI Input (HD Model)
DVI Source to BG/DSK Input
Table 3-3. Equipment List, Basic PresentationPRO-II System
Qty.
Item
Note
1
PresentationPRO-II Chassis
1
Video Projector and cable
Customer supplied
1
Analog Monitor and cable
Customer supplied
1
Ethernet Hub or Switch
Customer supplied (Optional, with External Controller)
2
Ethernet cables
Customer supplied (Optional, with External Controller)
1
DVI-DVI cable
Customer supplied (for BG/DSK input)
1
Video cable
Customer supplied (for SD-SDI or HD-SDI input)
TBD
Dedicated sources
Analog video as required (customer supplied)