Sanyo POA-PN03C User Manual

 

Press SELECT button again. The following network setting pallet appears on the screen. 
Enter the specified network addresses.

There are 2 ways to enter the numbers, one is by using the point buttons (d e ) on 
the remote control or on the projector, the other is by using the screen 10-key pallet by 
which the numbers can be entered directory. For further information see "How to enter 
the numbers with the screen 10-key pallet" (+ p.23).

After completing the entering of address, select "SET" and 
press SELECT button. The network unit starts re-booting 
and displays message "Please wait..." on the screen until 
the re-booting is complete. Do not disconnect the AC 
cord during this period. After that the network setting pallet will disappear on the screen. 

Now the installation is complete. The IP address of this projector is set to "192.168.1.201". 

IP address .............Sets IP address of the projector

Sub net ...................Sets Subnet mask. Normally sets 255.255.255.0

Gateway*

1

 .............Sets IP address of the default gateway (Router)

DNS*

2

 .......................Sets IP address of the DNS server. Must be set when using the e-mail function

*1   In the network environments not using a Gateway or Router, the Gateway address should be set to [0.0.0.0]. 
*2  If you do not use the functions E-mail or DNS server, it is also set [0.0.0.0] for the DNS address.

✐

The red frame moves  

sequentially left or right 

with  7 8 button.

The number up or 

down with d e but-

ton.